Seismix 5
The Seismix 5 active subwoofer is intended to compliment existing hi-fi and home theatre systems, enabling enhancement of low frequency performance. With styling identical to the Seismix 7 only smaller, the Seismix 5 offers a single 12 inch cast alloy bass driver and 200 watt inbuilt amplifier. It is versatile and compatible with a wide variety of small to large sized, sealed or vented, main and satellite speakers.
Features
- 200 watt low noise, mosfet amplifier w/ clipping protection
- Speaker level & line level input connection
- Electronic filtering
- high pass line level output
- adjustable 3rd order low pass from 45Hz to 95Hz
- Levels of protection
- mains fuse
- power supply fuses for internal power amplifier
- inputs protected against short circuit & incorrect connection
- limiting circuit preventing main amplifier clipping & severe distortion
- clipping/limiter LED indicator
Specifications
| Frequency Range: | 16Hz - 150Hz (-6dB) in room response |
| Bass Driver: | Nominal 12" (305mm) diameter paper cone driver developed for high level, low frequency reinforcement & large linear cone travel |
| Amplifier Power: | 400 watts RMS into the nominal 4 ohm driver Maximum instantaneous power 800 watts |
| Amplifier S/N Ratio: | >70 dB |
| Distortion - Input to Speaker: | <0.1% - @ 80 watts RMS |
| Line Level Inputs: | Left Input (mono) • Lo – 900mV RMS for maximum output • Hi – 100mV RMS Left + Right Input (stereo) • Lo – 450mV RMS for maximum output • Hi – 50mV RMS |
| Output: | 122 dB maximum SPL in room response |
| Auto Power On/Off: | 15 minute delay before switching to standby after no input signal |
| Phase Select: | 0º or 180º (relative to input signal) |
| Enclosure Type: | Bass reflex, front vented |
| Dimensions (HxWxD): | 460mm x 395mm x 440mm |
| Material: | 19mm & 25mm MDF |
| Finish: | Vinyl or laquered timber veneer |
| Weight: | 30kg |